Aleco Clear-Flex II with MaxBullet Mounting System (Food User Manual download pdf

FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE

2720 E. Avalon Ave. Muscle Shoals, AL 35661  Phone (256) 248-2402 or toll free 1-800-633-3120

Fax: 1-800-750-9616  email: info@aleco.com

Diagram 1

Side View

Wall

Lag Screw

MaxBullet

® Hardware

Bracket

Bullet

Seal opening here

Strips

Diagram 2

Front View w/ Strip Spacing

iagram 3

Clear-Flex II

Strip Door Installation

Instructions (Food Service Model)

Using the Maximus System Hardware

TOOLS NEEDED

• Pen or Pencil to Mark Drill Holes *

• Drill

• 5/16 Di ameter Fasteners

• Step Stool or Ladder

• Utility Knife to Cut Strips

IMPORTANT

Prior to installation, unroll all door strips and place them on

a clean, flat surface in a warm atmosphere for a minimum of

twenty-four (24) hours. This will allow the strips to return to

their original form.

1. Mount the MaxBullet® hardware bracket

using lag screws provided on the inside wall

of walk-in, centered appropriately above

conventional door opening.

2. Seal opening at ends of MaxBullet®

hardware bracket with NSF-approved

silicone sealant (Diagram 1).

3. Press the door strips onto the “bullets” of the

hardware bracket making certain that the

concave sides are facing each other

(Diagram 3). Attach strip numbers 1 and 3

(see Diagram 2) with concave side toward

you, leaving desired spacing between strips

as indicated by the diagram on reverse side

of this sheet. Then attach strip number 2

with concave side away from you. Proceed

with strip number 5 toward you, again

leaving the appropriate spacing as per

diagram on reverse side of this sheet.

Proceed until all strips are in place.

4. Once all of the door strips have been

attached, the strips can be trimmed to leave

¼” of clearance from the floor surface. Your

PVC door strips may be trimmed by using a

common utility knife to score and then be

torn by hand. The door strips need to

hang for 24 to 48 hours before final trim

to allow for proper alignment.

* NSF certification applies when hardware is installed with approved low-temp PVC strip material.

 web: www.aleco.com

P/N 477251

(Rev 0511)

1 2

Summary of Contents

Page 1 - Strip Door Installation

FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE 2720 E. Avalon Ave. Muscle Shoals, AL 35661  Phone (256) 248-2402 or toll free

Page 2 - STRIP PLACEMENT GUIDE

STRIP PLACEMENT GUIDE PARTIAL OVERLAP FULL OVERLAP 6” WIDE MATERIAL FULL OVERLAP 100% PARTIAL OVERLAP 66% PARTIAL OVERLAP 50%8” WIDE

Comments to this Manuals

No comments

Aleco Clear-Flex II with MaxBullet Mounting System (Food User Manual

Browse online or download User Manual for Tools Aleco Clear-Flex II with MaxBullet Mounting System (Food. Aleco Clear-Flex II with MaxBullet Mounting System (Food Service) User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Tools Aleco Clear-Flex II with MaxBullet Mounting System (Food